Fujitsu M10 - Page 372

Table C-1
XSCF setup command examples (continued)
XSCF command example Description Mandatory? Linked section
setpcl -p 0 -a 0=00-0 Registers a system board in a physical
partition configuration list
Example: System board 00-0 is
mapped to logical system board 0 of
physical partition 0.
Yes
(M10-4S)
"7.7 Creating a Physical
Partition Configuration List
(PCL)"
setpcl -p 0 -s policy=system Sets the configuration policy
Example: The configuration policy is
set to "All physical partitions" for
physical partition 0.
Optional "7.7 Creating a Physical
Partition Configuration List
(PCL)"
showboards -a Displays information on all mounted
PSBs
Yes "7.8 Assigning a System Board
(PSB) to a Physical Partition
(PPAR)"
addboard -c assign -p 0
00-0
Assigns a
system board (PSB) to a
physical partition
Example: System board 00-0 is added
to physical partition 0.
Yes
(M10-4S)
"7.8 Assigning a System Board
(PSB) to a Physical Partition
(PPAR)"
showpparmode -p 0 Checks the CPU Mode of the physical
partition
Optional "7.9 Setting a CPU Operational
Mode for the Physical Partition"
setpparmode -p
0 -m
cpumode=compatible
Sets the CPU Mode of the physical
partition to "compatible"
Optional
(M10-4S)
"7.9 Setting a CPU Operational
Mode for the Physical Partition"
Synchronizing the physical partition time with the XSCF time
showdate
Displays the XSCF clock date and time Yes "7.10 Synchronizing the
Physical Partition (PPAR) Time
and XSCF Time"
setdate -s 102016592012.00 Sets the XSCF clock date and time
Example: 16:59:00 on 2012/10/20 in
local time (JST) is set.
Yes "7.10 Synchronizing the
Physical Partition (PPAR) Time
and XSCF Time"
showdateoffset -p 0 Displays the difference between the
XSCF time and the physical
partition
time
Yes "7.10 Synchronizing the
Physical Partition (PPAR) Time
and XSCF Time"
resetdateoffset -p 0 Resets the difference between the
XSCF time and the physical partition
time
Yes "7.10 Synchronizing the
Physical Partition (PPAR) Time
and XSCF Time"
Configuring CPU Activation
showcodactivation Displays the CPU Activation key
information
Yes "7.11.2 Checking a CPU
Activation
key"
addcodactivation -F
file:///media/usb_msd/
XXXXX_XX.TXT
Adds a CPU Activation key
Example: The "XXXXX_XX.TXT" file
on a USB device is specified to add a
CPU Activation key.
Yes "7.11.3 Registering a CPU
Activation key"
setcod -p 0 -s cpu 4 Assigns CPU core resources to a
physical partition
Example: Four CPU cores are
assigned to physical
partition 0.
Yes "7.12 Assigning CPU Core
Resources"
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015358