Fujitsu M10 - Page 371

Table C-1
XSCF setup command examples (continued)
XSCF command example Description Mandatory? Linked section
showhostname -a Displays the set host names of the
master chassis and the chassis with
the standby XSCF
No "7.5.1 Setting an XSCF host
name and domain name"
sethostname bb#00
scf0-hostname
Sets a host name
Example: The host name "scf0-
hostname" is set for BB#00.
Optional "7.5.1 Setting an XSCF host
name and domain name"
sethostname
-d
example.com
Sets a DNS domain name
Example: The domain name
"example.com" is set.
Optional "7.5.1 Setting an XSCF host
name and domain name"
setnetwork bb#00-lan#0
-m 255.255.255.0
192.168.1.10
Configures an XSCF-LAN network
interface
Example: The IP address 192.168.1.10
and the net mask 255.255.255.0 are set
for XSCF-LAN#0 of BB#00.
Yes "7.5.2 Setting an Ethernet
(XSCF-LAN)
IP address"
setnetwork lan#0 -m
255.255.255.0 192.168.1.12
Sets a takeover IP address
Example: The takeover IP address
192.168.1.12 and the net mask
255.255.255.0 are set for XSCF-LAN#0.
Yes
(M10-4S)
"7.5.3 Setting a takeover IP
address"
showsscp -a Displays the SSCP link setting values No "7.5.4 Setting an SSCP IP
address"
setsscp Assigns an IP address to
an SSCP link Optional "7.5.4 Setting an SSCP IP
address"
showroute -a Displays routing information No "7.5.5 Setting the routing"
setroute -c add -n 0.0.0.0
-g 192.168.1.1 bb#00-lan#0
Sets routing information
Example: The default gateway IP
address 192.168.1.1 is added to
XSCF-LAN#0 of BB#00.
Yes "7.5.5 Setting the routing"
applynetwork Applies XSCF network information to
the XSCF
Yes "7.5.6
Applying network
settings"
rebootxscf -a Resets the XSCF Yes "7.5.6 Applying network
settings"
Setting memory mirror mode
showfru -a Displays the set information for all
devices
Optional "7.6 Configuring Memory
Mirroring"
setupfru -m y sb 00-0 Sets the memory mounted on a PSB to
mirror mode
Example: All CPUs under PSB 00-0
are set to memory mirror
mode.
Optional "7.6 Configuring Memory
Mirroring"
Configuring a physical partition
showpcl -p 0 Displays physical partition (PPAR)
configuration information (PCL)
Yes
(M10-4S)
"7.7 Creating a Physical
Partition Configuration List
(PCL)"
Appendix C Setup Command Workflow 357