Fujitsu M10 - Page 370

Table C-1
XSCF setup command examples (continued)
XSCF command example Description Mandatory? Linked section
showhardconf -u Displays the number of mounted
units by FRU
No "6.8 Checking the Component
Status"
showlogs error Displays an error log Yes "6.8 Checking the Component
Status"
showstatus Displays information on a degraded
unit
Yes "6.8 Checking the Component
Status"
Creating an XSCF user
showpasswordpolicy Displays the password policy settings No "7.1 Setting the Password
Policy"
setpasswordpolicy -y 3
-m
8 -d 2 -u 0 -l 0 -o 0 -M 60
-w 15
Sets the system password policy
Example: The following is set: a retry
count of 3, a password length of 8
characters including at least 2
numeric characters, an expiration
time of 60 days, and 15 days ahead
for the
start date for warnings before
the password expires.
Yes "7.1 Setting the Password
Policy"
adduser jsmith Creates a user account Yes "7.2 Setting a User Account
and Password"
password jsmith Sets a password Yes "7.2 Setting a User Account
and Password"
setprivileges jsmith
useradm platadm
Assigns a user privilege Yes "7.2 Setting a User Account
and Password"
showuser -l Checks
information on a created user
account
No "7.2 Setting a User Account
and Password"
Configuring the Telnet/SSH/HTTPS service
showtelnet Displays the Telnet service status No "7.3.1 Configuring the Telnet
service"
settelnet -c enabled Starts the Telnet service Optional "7.3.1 Configuring the Telnet
service"
showssh Displays SSH service information No "7.3.2 Configuring the SSH
service"
setssh -c enabled Starts the SSH
service Optional "7.3.2 Configuring the SSH
service"
setssh -c genhostkey Generates a host key Optional "7.3.2 Configuring the SSH
service"
showhttps Displays the HTTPS service status No "7.4 Configuring the HTTPS
Service"
sethttps -c enable Starts the HTTPS service Optional "7.4 Configuring the HTTPS
Service"
Configuring the XSCF network
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015356