Fujitsu M10 - Appendix C Setup Command Workflow; Table C-1 XSCF setup command examples

Table C-1
XSCF setup command examples
XSCF command example Description Mandatory? Linked section
Making the initial system settings
version -c xcp Displays the XCP version Yes
"6.4 Checking the XCP Version"
flashupdate -c sync Updates the XCP version to match it
on any chassis that has a different
XCP version
Yes
"6.4 Checking the XCP Version"
showaltitude Displays the system altitude Yes "6.5 Checking the Altitude
Setting"
setaltitude -s altitude=100 Sets the altitude
Example: The system altitude is set to
100 m.
Optional "6.5 Checking the Altitude
Setting"
rebootxscf -y -a Resets the XSCF Optional
(*1)
"6.5 Checking the Altitude
Setting"
showtimezone -c tz Displays the XSCF time zone No
"6.6 Checking the Time Setting"
settimezone -c settz -a Lists the time zones that can be set No "6.6 Checking the Time Setting"
settimezone -c settz -s
Asia/Tokyo
Sets the time zone
Example: "Asia/Tokyo" is set.
Yes "6.6 Checking the Time Setting"
showdate Displays the XSCF clock date and time Yes "6.6 Checking the Time Setting"
setdate -s 102016592012.00 Sets the XSCF clock date and time
Example: 16:59:00 on 2012/10/20 in
local time (JST) is set.
Yes "6.6 Checking the Time Setting"
testsb -v -p -s -a -y Performs an initial diagnosis of the
PSB
Yes "6.7 Performing a Diagnosis
Test"
showhardconf -M Displays information on each FRU Yes "6.8 Checking the Component
Status"
Appendix C
Setup Command Workflow
This appendix describes the workflow of the XSCF commands executed in
installation of the SPARC M10 systems.
For details, see the linked sections listed in Table C-1.
355