Fujitsu M10 User Manual

9.3.1 Changing a multiple-BB configuration into 1BB configurations
and releasing their connections 265
9.3.2 Installing expansion rack 1 268
9.3.3 Installing the SPARC M10-4S in expansion rack 1 268
9.4 Installing Expansion Rack 2 269
9.5 Adding Expansion Racks 1 and 2 271
9.5.1 Changing a multiple-BB configuration into 1BB configurations
and releasing
their connections 271
9.5.2 Performing the work of installing the expansion racks 274
9.5.3 Installing the SPARC M10-4S in the expansion racks 274
Chapter 10 Removing a System with a Building Block Configuration 277
10.1 Preparing the Necessary Tools for Removal 277
10.2 Removing the SPARC M10-4S 277
10.2.1 Removing the server while the
target physical partition (PPAR)
is operating 278
10.2.2 Removing the server after stopping the target physical partition
(PPAR) 288
10.2.3 Removing the server after stopping all the physical partitions
(PPARs) 290
10.3 Removal of Expansion Rack 2, and Decrease in the Number of SPARC
M10-4S Units to Four or Less 293
Appendix
A Troubleshooting 297
A.1 Understanding the Usual Problems and Their Corrective Actions 297
A.2 Understanding Commands for Troubleshooting 298
A.2.1 Checking the component status 298
A.2.2 Checking the contents of logs 310
A.2.3 Checking information on a component where a failure or
degradation occurred 311
A.2.4 Checking diagnosis results 312
A.3 How to Restore
a BB-ID from an Incorrect Setting 316
A.3.1 BB-IDs not set (BB-ID 00) 316
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015viii

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English