First-time setup of your device
Switching on the device for the first time
Switchingonforthefirst time
The device must be supplied with power through the mains adapter during this process.
When you s witch on the device for the first time, the s upplied software is
installed and configure d. Because this procedure must not be interrupted,
you should set aside eno ugh time for it to be fully completed a nd connect
the device to the mains using the mains adapter.
During the installation pro cess, DO NOT restart the device unless
you are requested to do so!
You can find information on how to restore the operating system, drivers, manuals
and special software in the "Recovery Process" manual.
To make it easier to use your de
vice for the first time, the operating system
is p re-installed on the hard d
isk.
► Switch on your device.
► During installation, follow the instructions on screen.
Consult the operating system m anual if anything is unclear about the requested input data .
If a Windows operating system is installed on your device , you will find more
information on the system and drivers, help programmes, updates, manuals etc.
on the device or on the Inte rnet under "
http://ts.fujitsu.com/suppor t".
10 A26391-K245-Z220-1-7619, edition 1
To Next Page
Loading...
Need help?
General