35
PRIMERGY RX100 S3 User’s Guide
1
Overview
■ Cautions for Handling CD-ROMs
• When removing the disk from the case, pull the disk up while pressing the center holder of the case as
shown in the figure below.
• Hold the CR-ROM on its edge to avoid contact with the disk surface.
• Do not contaminate the CD-ROM surface with fingerprints, oil, or dust. If the disk is dirty, wipe it
from the center to the edge with a dry, soft cloth. Do not use benzine, thinner, water, record sprays,
antistatics, or silicone clothes.
• Be careful not to scratch the CD-ROM surface.
• Avoid heat.
• Do not bend the floppy disk or place heavy objects on it.
• Do not use a ball point pen or pencil on the label (printed) side.
• Do not apply stickers to the label side. Abnormal vibration can occur due to eccentricity.
• When the CD-ROM is moved from a cold place into a warm place, dew condensation may occur,
resulting in data read errors. If this is the case, wipe droplets away with a dry, soft cloth and let the
unit dry naturally. Do not use a hair dryer.
• To avoid dust, scratches, or deformation, store CD-ROMs in the case whenever not in use.
• Do not store CD-ROMs in areas of high temperature exposed to direct sunlight for many hours or
near heating appliances.
■ Inserting the CD-ROM
1 Make sure the server is turned on and press the CD-ROM eject button.
The CD-ROM tray comes out a little.
2 Pull the CD-ROM tray out.
CD-ROM
eject button
CD-ROM tray
To Next Page
Loading...
Need help?
General