30 Operating manual RX300 S3
Transporting the Server Important Notes
3.3 Transporting the Server
V CAUTION!
Only transport the server to the new site in its original packaging or in
packaging that protects it from knocks and jolts. Do not unpack the server
until it is at its installation location.
If you need to lift or transport the server, ask other people to help you.
3.4 Notes on Installing into the Rack
V CAUTION!
● For safety reasons, at least two people are required to install the
system in the rack because of its weight and size.
● When connecting and disconnecting cables, observe the relevant
notes in the chapter „Important notes“ in the technical manual for the
corresponding rack. The technical manual is supplied with the corre-
sponding rack.
● Make sure when installing the rack that the anti-tilt mechanism is
properly mounted.
● For safety reasons, no more than one unit may be removed from the
rack at any one time during installation and maintenance work.
● If several units are removed from the rack at the same time, there is
a risk that the rack will tilt forward.
● The rack must be connected to the power supply by an authorized
specialist (electrician).
● If the server is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for non-industrial (public) power supply networks for the
type A connector.
To Next Page
Loading...
