RX300 S3 Operating manual 73
Troubleshooting and Tips Error Messages on the Monitor
Power failure during enable sequence
The enable sequence was aborted. The PCI board was either not installed
correctly (tilted) or the PCI board is defective.
Ê Remove and insert the PCI board correctly.
Ê Repeat the enable process (see section “Replacing hot-plug PCI Boards” on
page 90).
If the error occurs again, it is probable that the PCI board is defective.
Ê Repeat the enable process with a new PCI board.
If the error continue to occur, contact our Service group.
7.14 Error Messages on the Monitor
The meanings of the error messages are explained in the manual for the BIOS
Setup and in the documentation for the relevant components and programs on
the PRIMERGY ServerBooks DVD.
To Next Page
Loading...
