Fujitsu Primergy RX300 S3 - Drives Are Reported as Dead; Added Drive Reported Defective

RX300 S3 Operating manual 71
Troubleshooting and Tips Drives Are Reported as „Dead“
7.10 Drives Are Reported as „Dead“
This error message may occur when the onboard SAS controller supports RAID
functionality or the server has a PCI RAID controller:
RAID controller configuration incorrect
Ê Check and correct the settings for the drives with the RAID controller utility.
Further information is provided in the manual on the RAID controller.
7.11 Added Drive Reported Defective
RAID controller is not configured for this hard disk drive
The drive was probably installed when the system was switched OFF.
Ê Reconfigure the RAID controller for the drive with the corresponding utility.
Information is contained in the documentation on the RAID controller.
or
Ê Reinstall the drive while the system is switched ON.
If the hard disk drive continues to be shown as defective, then replace it (see
section “Installing/Removing HDD Module” on page 80 and section “Hot-swap
for HDD Modules” on page 87).