78 Operating manual RX300 S3
Hot-plug Hard Disk Drives Hot-plug Components
8.2.2 Removing/installing the dummy module
Free slots are provided with a dummy module that must be removed before
installing an additional HDD module.
Removing/installing the 3.5-inch dummy module
Figure 19: Removing the 3.5-inch dummy module
Ê Press both tabs on the dummy module together (see figure 19) until the
locking mechanism disengages and remove the dummy module from the
mounting location.
The dummy module is installed in the reverse order.
V CAUTION!
Keep the dummy module for future use. If the HDD module is removed
again and not replaced with a new module, the dummy module must be
reinstalled due to cooling, to comply with applicable EMC regulations
(regulations on electromagnetic compatibility) and to protect against fire.
To Next Page
Loading...
