RX300 S3 Operating manual 79
Hot-plug Components Hot-plug Hard Disk Drives
Removing/installing the 2.5-inch dummy module
Figure 20: Removing the 2.5-inch dummy module
Ê Press both tabs on the dummy module together until the locking mechanism
disengages (1) and remove the dummy module from the mounting location
(2).
The dummy module is installed in the reverse order.
V CAUTION!
Keep the dummy module for future use. If the HDD module is removed
again and not replaced with a new module, the dummy module must be
reinstalled due to cooling, to comply with applicable EMC regulations
(regulations on electromagnetic compatibility) and to protect against fire.
To Next Page
Loading...
