Fujitsu Primergy RX300 S3 - Mounting the PCI Board into the Pull out Aid

94 Operating manual RX300 S3
Hot-plug PCI Boards Hot-plug Components
8.4.1 Mounting the PCI board into the pull out aid
Before installing the PCI board, it must be mounted into the pull out aid:
Figure 31: Mounting the PCI board into the pull out aid
Ê Press the two green snap-fits down completely (1) and remove it from the
guidances (2).
Ê Place the PCI board into the slot of the pull out aid (3).
Ê Carefully press down the green snap-fits (4) until the PCI board is fixed.
Do not jam the board.
2
1
3
2
1
4
4