RX300 S3 Operating manual 93
Hot-plug Components Hot-plug PCI Boards
Ê Lift the green movable snap-fits not more than 1 mm, and take the PCI board
off.
Ê Mount the new PCI board into the pull out aid as described in the next
section.
Ê Insert the pre-assembled PCI board into the hot-plug PCI slot.
Ê Secure the assembly with the locking slide on the card guide (move it in the
direction of the server front side).
Ê Activate the board using the relevant software or by pressing the button (a).
The power indicator for the hot-plug PCI slot (see table 5 on page 56)
flashes green. The slot is in the enable sequence.
Ê Wait until the power indicator lights constant. The slot is now powered on.
I If the boards do not match, the new board will not be commissioned
(see section “Hot-Plug PCI Power Indicator not Lighting after
Replacing the Board” on page 72).
Ê Replace the housing cover (see section “Opening/Closing the Housing” on
page 95).
To Next Page
Loading...
