RX300 S3 Operating manual 67
7 Troubleshooting and Tips
V CAUTION!
Observe the safety information in the „Security“ manual and in
chapter “Important Notes” on page 23.
If a problem occurs, try to resolve it as described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps and the circumstances that led to the fault. Also make
a list of any error messages that were displayed.
Ê Switch OFF the server.
Ê Contact our customer service team.
7.1 Power-On Indicator Remains Dark
The power-on indicator remains dark after switching ON.
Power cord incorrectly connected
Ê Make sure that the power cable is correctly connected to the server and to
the grounded socket.
Power supply overloaded
Ê Pull the server power plug(s) out of the power socket(s).
Ê Wait a few seconds before you plug it into the grounded socket(s) again.
Ê Switch ON your server.
To Next Page
Loading...
