RX300 S3 Operating manual 49
5 Preparation for Use and
Operation
V CAUTION!
Please note the safety instructions in chapter “Important Notes” on
page 23.
5.1 Operating and Indicator Elements
5.1.1 The Front
The operating and indicator elements on the front side are show in figure 13 on
page 50.
Operating elements
ON/OFF button
When the system is switched OFF, it can be switched ON again by
pressing the ON/OFF button. When the system is operating,
pressing the ON/OFF button will switch OFF the system.
I The ON/OFF button does not disconnect the server from the
mains. To disconnect from the mains completely, remove the
power plug(s).
NMI NMI button
I Please do not press! The NMI button may only be used by
Service.
RST Reset button
Pressing the reset button reboots the system.
To Next Page
Loading...
