92 Operating manual RX300 S3
Hot-plug PCI Boards Hot-plug Components
Figure 30: Installing hot-plug PCI board
Ê Move the locking slide on the card guide in the direction of the rear side (1).
V CAUTION!
The locking slide may only be moved if both indicators for the relevant
PCI slot are not lighting.
The locking slide activates the MRL sensor, which informs the
operating system that the PCI slot has been deactivated.
If the MRL sensor is activated without authorization (one of the LEDs
is still lighting) and there is a board in the PCI slot, an NMI is initiated
(blue screen). This state cannot be exited. There is a risk that data
may be lost.
Ê Remove all cables attached to the board.
Ê Using the pull out aid, remove carefully the board out of the PCI slot (2).
a
1
2
To Next Page
Loading...
