RX300 S3 Operating manual 43
Hardware Installation Installing/Removing the Server into/from the Rac
Figure 9: Installing the server
V CAUTION!
At least two people are needed to position the server in the rack.
Ê Insert the prepared server into the projecting internal telescopic rails (1) until
the rails click into place.
Ê Release the locking mechanism of both rails (2) and insert the server
completely into the rack (3).
Ê Fasten the server (4) using two knurled screws (front panel).
To remove the server, follow the same procedure in the reverse order.
2
3
3
4
4
1
To Next Page
Loading...
