46 Operating manual RX300 S3
Connecting the Server to the Line Voltage Hardware Installation
V CAUTION!
The server automatically sets itself to a voltage in the range of 200 V -
240 V. Make sure that your local voltage is within this range.
Figure 12: Connecting the server to the line voltage
Ê Connect the insulated connector of the power cable to the power supply unit
of the server (1), and the power plug into the mains socket strip of the rack
(see Technical Manual of the rack).
I A phase redundancy in the power supply of the server can be set up if
two hot-plug power supply units are installed.
In this case the two power supply units can be directly connected to two
different phases.
To Next Page
Loading...
