Fujitsu Primergy RX300 S3

To Next Page

To Previous Page

RX300 S3 Operating manual 99

Abbreviations

FRU

Field Replaceable Unit

FSB

Front Side Bus

GAM

Global Array Manager

GUI

Graphical User Interface

HDD

Hard Disk Drive

HSC

Hot-Swap Controller

I²C

Inter-Integrated Circuit

I/O

Input/Output

ICM

Intelligent Chassis Management

Identification

IDE

Intergrated Drive Electronics

IME

Intergrated Mirroring Enhanced

IRQ

Interrupt Request Line

LAN

Local Area Network

Main Page

Table of Contents3
Introduction7
Overview of the Documentation7
Features9
Notational Conventions18
Technical Data18
Installation Steps: Overview21
Important Notes23
Safety23
CE Certificate29
Notes on Installing into the Rack30
Transporting the Server30
Environment Protection31
Hardware Installation33
Installing/Removing the Server Into/From the Rack34
Unpacking the Server34
Mounting into the Primecenter/Datacenter Rack38
Mounting into 3Rd-Party Racks41
Installing the Server42
- Connecting Devices to Server44
- Connecting the Server to the Line Voltage45
- Instructions on Connecting and Disconnecting Cables47
- Preparation for Use and Operation49
- Operating and Indicator Elements49
The Front49
The Rear Side54
Indicators on the Hot-Plug CPU and System Fans57
- Switching the Server on and off58
- Configuring the Server60
Configuration with Serverstart60
Configuration Without Serverstart61
- Starting up Hot-Plug PCI Slots62
- Cleaning the Server63
- Property and Data Protection65
- BIOS Setup Security Functions65
- Troubleshooting and Tips67
- Power-On Indicator Remains Dark67
- The Server Switches Itself off68
- The Monitor Remains Dark68
- Flickering Stripes Across the Monitor69
- No Monitor Display or the Display Drifts69
- No Mouse Pointer Displayed on the Monitor69
- The Floppy Disk Cannot be Read or Written70
- Incorrect Time And/Or Date70
- System Fails to Boot70
- Drives Are Reported as „Dead71
- Added Drive Reported Defective71
- Hot-Plug PCI Error Indicator Lighting72
- Hot-Plug PCI Power Indicator Not Lighting after Replacing the Board72
- Error Messages on the Monitor73
- Hot-Plug Components75
- Hot-Plug Power Supply Units75
Removing the Dummy Module75
Adding a Hot-Plug Power Supply Unit76
Replacing a Hot-Plug Power Supply Unit76
Handling Hard Disk Drives/Hdd Modules77
Hot-Plug Hard Disk Drives77
Removing/Installing the Dummy Module78
Installing/Removing HDD Module80
Hot-Swap for HDD Modules87
Replacing a Hot-Plug Fan88
Replacing the Fan89
Replacing Hot-Plug PCI Boards90
Mounting the PCI Board into the Pull out Aid94
Opening/Closing the Housing95
Abbreviations97
Related Publications103
Index105

Fujitsu Primergy RX300 S3 - Page 99

Table of Contents

Other manuals for Fujitsu Primergy RX300 S3

Related product manuals