124
Chapter 4 Manual OS Installation
2 Turned on the server and configure RAID. If RAID is not required to be
configured, proceed to step 3.
Turn off the server after configuring the array system.
To configure the array system with onboard SCSI array controller
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up the
SCSI Setup Utility.
RAID 1 is configured. For more details, refer to "8.3.6 Configuring and Deleting the Array
System" (
Jpg.245).
To configure the array system with SCSI array controller card (PG-140D1)
Turn on the server to display the following message and press the [Ctrl] + [H] key to start up the
WebBIOS.
The array system is configured by using WebBIOS. For more details, refer to the manual which
comes with the SCSI array controller card.
3 Prepare the Windows Server 2003 CD-ROM.
Turn on the server and insert the Windows Server 2003 CD-ROM or CD-ROM Disk1 for SBS
2003 immediately into the CD-ROM drive. Confirm that the floppy drive is empty. When the
active area is specified on the hard disk, the following message appears.
Pressing any key while this message is displayed boots the system from the CD-ROM.
4 The Windows Server 2003 setup window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
` This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
5 Install the Drivers for onboard SCSI controller or SCSI array controller card
manually.
1. When the following message appears, press the [S] key.
Press Ctrl-C to start LSI Logic Configuration Utility
Press <Ctrl><H> for WebBIOS
Press any key to boot from CD....
Press F6 if you need to install a third party SCSI or RAID
driver ...
To specify additional SCSI adapters, CD-ROM drives, or
special disk controllers for use with Windows, including
those for which you have a devicesupport disk from a mass
storage device manufacturer, press S.
To Next Page
Loading...
Need help?
General