125
PRIMERGY TX150 S4 User’s Guide
4
Manual OS Installation
2. When the "Please insert the disk labeled Manufacturer-supplied hardware support
disk into Drive A:" message appears, insert the driver disk created and press the
[Enter] key.
The following message appears.
3. Select following item and press the [Enter] key.
• For SCSI array controller card (PG-140D1)
• For onboard SCSI controller
4. When the following message appears, press the [S] key.
5. Follow the instructions in the window to perform installation
The message which prompts you to set the floppy disk appears during the installation, set
the driver disk and push the [Enter] key.
6 Follow the instructions from the setup program to continue the installation
procedure.
If a message indicating that the driver has not passed Windows Logo testing to verify its
compatibility with Windows appears, select [Yes] to continue the installation procedure.
You have chosen to configure a SCSI Adapter for use with
Windows, using a device support disk provided by an
adapter manufacturer.
Select the SCSI Adapter you want from the following list,
or press ESC to return to the
previous screen.
LSI MEGARAID Products for Windows 2003(x86)
LSI Logic PCI SCSI/FC MPI Miniport Driver(Server 2003
32bit)
The driver you provided seems to be newer than the Windows
default driver. Windows already has a driver that you can
use for "LSI MEGARAID Products for Windows 2003(x86)"(or
"LSI Logic PCI SCSI/FC MPI Miniport Driver(Server 2003
32bit)) Unless the device on the floppy disk, you should
use the driver in Windows.
To Next Page
Loading...
Need help?
General