126
Chapter 4 Manual OS Installation
For SBS 2003
The server is restarted after installing the operating system.
1. After restarting the server, log on to the server with the Administrator account.
The installation of server tools and the application is started, and the following window
appears.
2. Click [Cancel] to cancel the installation.
7 Install the LAN driver.
Install the LAN driver using the driver disk created from the ServerStart CD-ROM. For more
details, refer to "4.3 Installing the LAN Driver" (
Jpg.133).
8 Install the LAN driver advanced set up tool.
For information about onboard LAN driver advanced setup tool, refer to "5.6.1 BACS
Installation" (Jpg.165). For information about LAN card advanced setup tool, refer to "5.7.1
Intel® PROSet Installation" (
Jpg.169).
9 Install the GEM318 driver.
1. Insert the ServerStart Disc 1 CD-ROM into the disk drive of server.
When the ServerStart window appears, exit ServerStart.
2. Click [Start] → [Administrative Tools] → [Computer Management].
3. Click [Device Manager].
4. Double-click [HP SDR GEM SCSI Processor Device] under [System devices].
The properties window appears.
5. Click the [Driver] tab and click [Update Driver].
The "Device Driver Upgrade Wizard" window appears.
6. Click [Next].
7. Select [Find an optimum driver (Recommended)] and click [Next].
8. Select only [CD-ROM drive] in [Search location options] and click [Next].
9. Select [Install another disk] and click [Next].
10. Select [FSC SCSI Termination Module GEM 318] and click [Next].
Installation starts. When it is completed, a completion message appears.
11. Click [Finish].
To Next Page
Loading...
Need help?
General