FUTABA 14SG S.Bus2 - Page 152

152
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
●Throttle Curve (Example)
The curves shown below are created by inputting
the data of the 5 points 0% (low side), 25%,
50% (center), 75%, 100% (high) side for each
condition. When actually creating a curve, enter the
parameters specied per the model (or the reference
value).
Curve setting examples
Throttle Hover trim
Setting method
●SetthefunctiontoACT([ON]).(initialsetting)
●Selecttheadjustmentknob.
 Selectionexample:RD(initialsetting)
●Thetrimoperationmode(Mode:CTRM/
NORM)canbeselected.
 CTRM mode:Maximumrate ofchange
nearcenterby centertrimoperation
(recommended)
 NORM mode: Normaltrim(horizontal
movementtrim)operation.
●Thetrimratecanbeadjustedandthe
operationdirectioncanbeset.
●Trimadjustmentrange(Range)setting
 Withsmallervalues,thetrimisonlyactive
nearthecenter.
[Throttlehovertrimsetting]