147
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
RUDDER2
RUDDER
RUDDER
V-TAIL
RUDDER2
Winglet
RUDDER1
Winglet
atFlyingwing
atFlyingwing
() ()
AIL3
AIL3
(ChipAileron)
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
Rudder →Aileron
[Corresponding model type]:
Airplane/glider, general
7KLVIXQFWLRQLVXVHGZKHQ\RXZDQWWRPL[WKH
DLOHURQVZLWKUXGGHURSHUDWLRQ,WLVXVHGZKHQ
UXGGHULVDSSOLHGGXULQJUROOPDQHXYHUVNQLIH
HGJHHWFRIDFUREDWLFSODQHV,WFDQEHXVHGWR
EDQNVFDOHPRGHOVODUJHPRGHOVHWFOLNHDIXOO
size plane.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ/LQNLQJFDQEHVHW/LQNWKLVPL[WRRWKHUPL[HV
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWRWKH>@LWHP
of the switch and tap the screen to call the
selection screen. Then, select the switch and
set its ON direction. (Always ON at "--" setting)
(For a description of the switch selection
method, see back of this manual.)
ŏ:KHQVHWWLQJD95WDSWRWKH)LQHWXQLQJ
"--" item and tap the screen to call the
selection screen and then select the VR. The
adjustment rate can be set.
The VR operation mode can also be set.
)RUDGHVFULSWLRQRIWKHÀQHWXQLQJ95VHWWLQJ
method, see the description at the back of
this manual.)
ŏ$PL[LQJFXUYHFDQEHVHW
(For a description of the curve setting
method, see the back of this manual.)
ŏ:KHQOLQNLQJWDSWKH>/LQN@LWHP21LV
displayed.)
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Left/rightoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
ŏ6HOHFW>5XGGHUń$LOHURQ@DWWKHPRGHOPHQX
and call the setup screen shown below.
Tosetlinking,tapto
the[OFF]item
ŏ5HWXUQWR0RGHOPHQX