146
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Adjustmentof
elevatorservo
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Up/Downoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
ELEVATOR
ELEVATOR2
V-TAIL
ELEVATOR
ELEVATOR2
AILVATOR
FLP2
(CamberFlap)
FLP1
(CamberFlap)
Camberflap → ELE
Camber flap
→
ELE
Camber flap
→
ELE
[Corresponding model type]: Airplane/
glider,
DLOHURQVÁDSRUPRUH
7KLVPL[LQJLVXVHGWRFRUUHFWFKDQJHVHOHYDWRU
GLUHFWLRQJHQHUDWHGZKHQWKHFDPEHUÀDSVVSHHG
ÀDSVDUHXVHG
ŏ7KHHOHYDWRUVHUYRVXSVLGHGRZQVLGHUDWHFDQEH
adjusted. When the mixing direction is reversed
by the linkage, adjustments can be made by
changing the mixing rate polarity (+ or –).
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWRWKH>@LWHP
of the switch and tap the screen to call the
selection screen. Then, select the switch and
set its ON direction. (Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
ŏ7DSHOHYDWRUVHUYRV$GMXVWWKHPL[LQJUDWH
:KHQWKHPL[LQJGLUHFWLRQLVUHYHUVHGE\WKHOLQNDJH
DGMXVWPHQWVFDQEHPDGHE\FKDQJLQJWKHPL[LQJUDWH
SRODULW\RU±
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJ
item and tap the screen to call the selection
screen, and then select the VR. The VR
operation mode can be selected.
ŏ$PL[LQJFXUYHFDQEHVHW
(For a description of the curve setting
method, see the description at the back of
this manual.)
ŏ6HOHFW>&DPEHUIODSń(/(@DWWKHPRGHO
menu and call the setup screen shown
below.
ŏ5HWXUQWR0RGHOPHQX