155
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Gyro
[Corresponding model type]: Airplane/glider/multicopter, general
7KLVIXQFWLRQLVXVHGZKHQD*<$6HULHVJ\UR
LVXVHGWRVWDELOL]HWKHDLUFUDIWVDWWLWXGH7KH
VHQVLWLYLW\DQGRSHUDWLRQPRGH1RUPDOPRGH*<
PRGHFDQEHVZLWFKHGZLWKDVZLWFK
ŏ7KUHHUDWHV5DWH5DWH5DWHFDQEH
switched.
ŏ8SWRD[HV*\UR*\UR*\URFDQEH
simultaneously controlled.
*Initial setting does not assign a sensitivity channel. Use the
)XQFWLRQPHQXRIWKH/LQNDJHPHQXWRDVVLJQWKHVHQVLWLYLW\
FKDQQHO*\UR*\UR*\URXVHGWRDYDFDQWFKDQQHO
beforehand.
6HW>&RQWURO@DQG>7ULP@RWKHUWKDQ)XQFWLRQWR>@
ŏ7KUHHUDWHV5DWH5DWH5DWHFDQEHXVHG
Tap to the [Rate] item. Adjust the rate.
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@
ŏ:KHQD)XWDED*<$J\URLVXVHGZKHQ>*<@W\SHLVVHOHFWHGWKH
sensitivity set value is directly read in both the AVCS and Normal modes.
ŏ:KHQVHWWLQJDVZLWFKWDSWKH6ZLWFKLWHPDQGWDSWKHEXWWRQWRFDOO
the selection screen, and then select the switch and set its ON direction.
(For a description of the switch selection method, see the description at
the end of this manual.)
ŏ6HOHFW>*\UR@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
Theoperationmode
(AVCS/NOR)and
sensitivityofthe3
axesGyro/Gyro2/
Gyro3canbeset.
3rate(gyrogain)
adjustment
Conditiongroup/
singlemodeselection
(Gr./Sngl)
TheON/OFFswitchof
gyroischosen.
TappingthiswillchangeINHtoeitherONorOFF
andenableoperation.Adjustmentofthethree
rates(sensitivity)andswitchingbetweenNormal
andAVCSispossible.
ŏ5HWXUQWR0RGHOPHQX