FUTABA T16IZ SUPER - Page 156

156
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
(Example) Setting three axis using a GYA450 and GYA451 (2)
ŏ:LQJW\SH$LOHURQVHUYRVPRXQWHGIXVHODJHVHOHFWHG
ŏ6HW
5CH → Gyro
(GYA451AIL),
7CH → Gyro2
(GYA451ELE),
8CH → Gyro3
(GYA450RUD),
ControlandTrim → "--"
: at
the Function menu of the Linkage menu.
ŏ*\URVHWWLQJRIWKH0RGHOPHQX
6HWVRWKDW5DWHLVWXUQHGRQDWWKHEDFNSRVLWLRQRIVZLWFK(
DQG5DWHLVWXUQHG21DWWKHIURQWSRVLWLRQ6LQFHVZLWFK(LV
WXUQHG2))DWWKHFHQWHU5DWHUHPDLQV>,1+@
Rudderservo
Elevatorservo
Aileronservo
S.BUS2port
S.BUSReceiver
GYA451
GYA451
GYA450
GAIN0％
AVCS
NORMAL
WhenAVCSisusedwe
recommendthatthe
sensitivityCHbesetto
the3-position.
Rate ACT Type Switch Gyro Gyro ２ Gyro ３
1 OFF/ON GY SE AVCS:60% AVCS:60% AVCS:60%
2INH
3 ON/OFF GY SE Normal:60% Normal:60% Normal:60%