FUTABA T16SZ

124
＜ Modelmenu(CommonFunctions) ＞
AFR
The angle and curve of each operation function can be set. [All model types]
$)5IXQFWLRQLVXVHGWRDGMXVWWKHWKURZDQG
RSHUDWLRQFXUYHRIWKHVWLFNOHYHUDQGVZLWFK
IXQFWLRQVIRUHDFKÀLJKWFRQGLWLRQ
7KLVLVQRUPDOO\XVHGDIWHU(QG3RLQWKDVGH¿QHG
WKHPD[LPXPWKURZ:KHQPL[LQJLVDSSOLHGIURP
RQHFKDQQHOWRDQRWKHUFKDQQHOERWKFKDQQHOV
FDQEHDGMXVWHGDWWKHVDPHWLPHE\DGMXVWLQJWKH
RSHUDWLRQUDWHWKURXJKWKH$)5IXQFWLRQ
ŏ2SHUDWLRQFXUYHDGMXVWPHQW7KUHHW\SHV
of curves (EXP1, EXP2, and Point) can be
VHOHFWHG$PD[LPXPSRLQWVFXUYHFDQEH
used for the point curve type. (Initial setting:
9 points) The number of points can also be
increased and decreased and curves from
complex curves to simple curves can be
used.
ŏ2SHUDWLRQVSHHGDGMXVWPHQW7KHRSHUDWLRQ
speed of each function when the function
is operated (including at flight condition
VZLWFKLQJFDQEHDGMXVWHG7KHIXQFWLRQ
operates smoothly at a constant speed
corresponding to the set speed.
ŏ6HOHFW>$)5@DWWKHPRGHOPHQXDQGFDOO
the setup screen shown below.
Function selection
1. When the function select button is tapped, a selection screen appears.
2. Select the function you want to set at the selection screen.
WhenD/RisturnedON,thedisplaywill
show"D/R----",andtherudderangle(rate)
andEXPcanbesetwhenD/RisON.
● Operationcurvesetting
(Foradescriptionofthesettingmethod,seethe
descriptionatthebackofthismanual.)
● Servospeedsetting
(Foradescriptionofthesetting
method,seethedescriptionat
thebackofthismanual.)
● Group/singlemodeswitch(Gr./Sngl)
(Formoreinformation,seethe
descriptionatthebackofthismanual.)
ŏ5HWXUQWR0RGHOPHQX
Left/right,Up/down,overall
adjustmentatRateAand
RateB
Curveselect
Separately ⇔ Combination
(Leftandright
symmetrical
curve.)
Curveselect
EXP1,EXP2,Pointcurve
100%
40%
Rate
Rate