FUTABA T16SZ

142
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Butterfly
[Corresponding model type]: Glider, 2 ailerons or more
This function allows powerful brake operation
by simultaneously raising the left and right
ailerons and lowering the flaps (camber flap,
EUDNHÀDS
This setting will allow the ailerons to be raised
while the flaps are simultaneously lowered.
Butterfly (crow) produces an extremely efficient
landing configuration by accomplishing the
following:
1. Slow the aircraft’s velocity.
3URYLGHZDVKRXWDWWKHZLQJWLSVWRUHGXFH
the tendency to tip stall.
3. Create more lift toward the center of the
ZLQJDOORZLQJLWWRÁ\DWDVORZHUVSHHG
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
VHWWLQJDVZLWFK$OZD\V21DW>@VHWWLQJ
ŏ7KHEXWWHUÁ\RSHUDWLRQUHIHUHQFHSRLQWFDQEH
RIIVHW:KHQWKHVFUHHQLVWDSSHGZLWKWKHRIIVHW
item selected when operated to the position to
EHFKDQJHGWKHUHIHUHQFHSRLQWLVRIIVHW,IWKH
reference point is offset too much, unexpected
operation may be performed.
ŏ7KHDLOHURQVDQGÁDSVRSHUDWLRQVSHHGFDQEH
DGMXVWHG,QVLGH2XWVLGH
ŏ$GHOD\FDQEHVHWIRUHDFKFRQGLWLRQ$FXW
VZLWFKZKLFKFDQWXUQ2))WKHGHOD\IXQFWLRQFDQ
also be set.
ŏ7KHGLIIHUHQWLDOUDWHFDQEHDGMXVWHG
*When servo binding occurs when setting the ailerons and
ÀDSVLQEXWWHUÀ\PL[LQJXVHWKH$)5IXQFWLRQWRDGMXVWWKH
rate.
ŏ6HOHFW>%XWWHUIO\@DWWKHPRGHO
menu and call the setup screen
shown below.
*The display screen is an example. The actual
screen depends on the model type.
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
Conditiongroup/single
modeselection(Gr./
Sngl)
TheON/OFFswitchof
mixingischosen.
Conditiondelaysetting
Conditiondelaycut
switch
Tonextpage
Thedifferentialrate
canbeadjusted.
Inspeed
Outspeed
（First）0〜27（Slowly）
*Thedisplayscreenisanexample.Theactual
screendependsontheModelType.
Whenoffsettingthebutterflyoperation
referencepoint,operatetothethrottle
stickpointyouwanttochangeandthen
touchtheOffsetbutton.Thereference
pointdisplays0%.When[Yes]istouched,
thereferencepointischanged.Then,
"Initializeelevatorcurve?"appears,
allowingyoutoconfirmyoursetting.