FUTABA T16SZ

153
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
RUDDER1
Winglet
atFlyingwing
()
RUDDER2
Winglet
atFlyingwing
()
Winglet
>&RUUHVSRQGLQJPRGHOW\SH@$LUSODQHJOLGHUZLQJOHW58'
This function adjusts the left and right rudder
angles of airplanes with winglets.
Winglets are used to improve the efficiency of
DLUFUDIWORZHULQJWKHOLIWLQGXFHGGUDJFDXVHGE\
wingtip vortices. The winglet is a vertical or angled
extension at the tips of each wing.
Winglets work by increasing the effective aspect
ratio wing without adding greatly to the structural
stress and hence necessary weight of its structure
DQH[WHQVLRQRIZLQJVSDQZRXOGDOVRSHUPLW
lowering of induced drag, though it would cause
parasitic drag and would require boosting the
VWUHQJWKRIWKHZLQJDQGKHQFHLWVZHLJKWWKHUH
would come a point at which no overall useful
saving would be made. A winglet helps to solve this
by effectively increasing the aspect ratio without
adding to the span of the wing.
(Rudder1/2)
Thetravelatrudderstickleftandright
operationcanbeindividuallyset.
ŏ6HOHFW>:LQJOHW@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
ŏ7UDYHODGMXVWPHQW
Tap to the item you want to adjust.
 $GMXVWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
SRODULW\RU
Conditiongroup/
singlemode
selection(Gr./Sngl)
ŏ5HWXUQWR0RGHOPHQX