FUTABA T16SZ

170
＜ Data ＞
This section describes the functions often used at the function setup screen. Refer to it when setting
each function.
Group/single mode switching (Gr/Singl)
When setting multiple flight conditions,
linking the setting contents with all conditions
(group mode) or setting independently (single
mode) can be selected. The mode can be
changed at the [Gr] item on each setup screen.
[Group/single mode switching]
ŏ*URXSPRGH*U
The same setting contents are set to all
WKHÁLJKWFRQGLWLRQV
ŏ6LQJOHPRGH6LQJO
 6HWWKLVPRGHZKHQWKHVHWWLQJFRQWHQWV
DUHQRWOLQNHGZLWKRWKHUFRQGLWLRQV
Condition delay setting
Unnecessary fuselage motion generated
when there are sudden changes in the servo
position and variations in the operating time
between channels can be suppressed by using
the condition delay function of the condition
select function [Condition select].
When the delay function is set at the
switching destination condition, a delay
corresponding to that amount is applied and the
related functions change smoothly.
>6HWWLQJPHWKRG@
6ZLWFKWRWKHFRQGLWLRQ\RXZDQWWRVHW
DQGWDSWKHGHOD\>YDOXH@
6HWWKHGHOD\XVLQJWKH
"▼▼""▼""▲
"
ʆʆEXWWRQV
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHaPD[LPXPGHOD\
(When the value is tapped, the delay is reset to the initial
value.)
ŲƓƈƕƄƗƌƒƑƖŃƕƈƏƄƗƈƇŃƗƒŃƳƌƊƋƗŃƆƒƑƇƌƗƌƒƑƖ
ŲƓƈƕƄƗƌƒƑƖŃƙƄƏƘƈŃƖƈƗƗƌƑƊ
Tapping the value setting buttons on each screen will cause value input
buttons to appear at the top of the panel.
Valueinputbuttonsdisplay
atthetopofthepanel
Pressingandholding
avaluewillreturnit
toitsdefaultsetting.
Smallchange
invalue
Largechange
invalue
Largechange
invalue
Common operations used in function setup screen
Tap
Tap
Tap