FUTABA T16SZ

35
＜ BeforeUse ＞
Rubber
grommet
Brass eyelet
Wood screw
Servo mount
2.3-2.6mm nut
washer
Rubber
grommet
Brass eyelet
Servo mount
2.3-2.6mm screw
(Helicopter) (Airplane/Glider)
ŶƈƕƙƒŃƏƈƄƇŃƚƌƕƈƖŃ
To prevent the servo lead cable from being
broken by vibration during flight, provide a
little slack in the cable and fasten it at suitable
points. Periodically check the cable during daily
maintenance.
Fasten about 5-10cm
from the servo outlet so
that the lead wire is neat
and secure.
Margin in the lead wire.
ŰƒƘƑƗƌƑƊŃƗƋƈŃƓƒƚƈƕŃƖƚƌƗƆƋŃ
:KHQPRXQWLQJDSRZHUVZLWFKWRDQ
airframe, make a rectangular hole that is a little
ODUJHUWKDQWKHWRWDOVWURNHRIWKHVZLWFKVR
WKDW\RXFDQWXUQWKHVZLWFK212))ZLWKRXW
binding.
$YRLGPRXQWLQJWKHVZLWFKZKHUHLWFDQEH
FRYHUHGE\HQJLQHRLODQGGXVW,QJHQHUDOLWLV
UHFRPPHQGHGWRPRXQWWKHSRZHUVZLWFKRQWKH
VLGHRIWKHIXVHODJHWKDWLVRSSRVLWHWKHPXIÀHU
ŶƄƉƈƗƜŃƓƕƈƆƄƘƗƌƒƑƖŃƚƋƈƑŃ
ƜƒƘŃƌƑƖƗƄƏƏŃƕƈƆƈƌƙƈƕŃƄƑƇŃ
ƖƈƕƙƒƖő
WARNING
Connectingconnectors
Besuretoinserttheconnectoruntilit
stopsatthedeepestpoint.
Howtoprotectthereceiverfromvibration
andwater
Wrapthereceiverwithsomething
softsuchasfoamrubbertoavoid
vibration.Ifthereisachanceof
gettingwet,putthereceiverina
waterproofbagorballoon.
Receiver'santenna
Nevercutthereceiver'santenna.Do
notbindthereceiver'santennawith
thecablesforservos.
Locatethereceiver'santennaasfaras
possiblefrommetalsorcarbonfiber
componentssuchasframes,cables,
etc.
*Cuttingorbindingthereceiver'santennawill
reducetheradioreceptionsensitivityandrange,
andmaycauseacrash.
Servothrow
Adjustyoursystemsothatpushrods
willnotbindorsagwhenoperating
theservostothefullextent.
*Ifexcessiveforceiscontinuouslyappliedtoaser-
vo,theservocouldbedamagedduetoforceon
thegeartrainand/orpowerconsumptioncausing
rapidbatterydrain.
Mountingservos
Useavibration-proofrubber(suchas
rubbergrommet)underaservowhen
mountingtheservoonaservomount.
Andbesurethattheservocasesdo
nottouchdirectlytothemetalparts
suchasservomount.
*Iftheservocasecontactstheairframedirectly,
vibrationwilltraveltoandpossiblydamagethe
servo.
ŰƒƘƑƗƌƑƊŃƗƋƈŃŶƈƕƙƒŃ
Switch
Lessthan5mmof
mountingplate
Attachedscrew
Switchcover