FUTABA T16SZ

59
＜ Systemmenu ＞
6WLFNPRGHVHOHFWLRQDQG--VWLFNVFDOLEUDWLRQ
Thestickissetat
neutral
Fullrightand
fullbottom
Fullleftand
fulltop
H/Wsetting
Usually, this H/W setting is unnecessary.
Please perform this calibration only if a change at
the center of a stick should arise after prolonged use.
&KRRVHWKHVWLFNWRFDOLEUDWHULJKWDQGOHIW
7KHVWLFNLVVHWDWQHXWUDODQGWKH>6HWQHXWUDO@
EXWWRQLVWDSSHG
How to Calibrate
7DSWKH&DOLEUDWLRQEXWWRQ
3OHDVHGRQRWSUHVVWKHVWLFNWRR¿UPO\LQDQ\GLUHFWLRQZKHQ
doing the calibration.
*Check after calibration to make sure that neutral is 0%, the
bottom right side is +100%, and the top left side is -100%.
ŏ7DSWKH>&DOLEUDWLRQ@EXWWRQLQWKH6\VWHP
PHQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
ŏ5HWXUQWR
6\VWHPPHQX
7KHVWLFNLVKHOGDWIXOOULJKWDQGIXOOERWWRP
GLDJRQDO7KH>6HWHQGSRLQW@EXWWRQLV
WDSSHG
7KHVWLFNLVKHOGDWIXOOOHIWDQGIXOOWRS
GLDJRQDO7KH>6HWHQGSRLQW@EXWWRQLV
WDSSHG
Tapped
Tapped
Tapped
Stick mode
Mode 1-4 can be chosen.
But, it isn't changed until data is reset.
To change the mode the stick ratchet
must be changed. Request that this
be done by Futaba Service. (Charged
PRGL¿FDWLRQ
AIL
THR
RUD
ELE
MODE1
AIL
ELE
RUD
THR
MODE2
AIL
THR
RUD
ELE
MODE3
AIL
ELE
RUD
THR
MODE4