145
< Modelmenu(Airplane/Glider/MulticopterFunctions) >
Snaproll
[Corresponding model type]: Airplane, general
This function selects the switch and rate
adjustment of each rudder, (ailerons, elevators, or
ÀDSVZKHQDVQDSUROOLVSHUIRUPHG
ŏ)RXUVQDSUROOGLUHFWLRQVFDQEHVHW5LJKWXS
ULJKWGRZQOHIWXSOHIWGRZQ
ŏ2SHUDWLRQPRGH:KHQ>0DVWHU@PRGHLVVHOHFWHG
WKH6QDS5ROOIXQFWLRQLVWXUQHG212))E\PDVWHU
switch in the state in which the direction switch
was switched to the direction in which you want
WRVQDSUROO:KHQ>6LQJOH@PRGHLVVHOHFWHGVQDS
roll in each direction can be executed by means
of independent switches.
ŏ$VDIHW\VZLWFKFDQEHVHW$VDVDIHW\PHDVXUH
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
ZKHQWKHVDIHW\VZLWFKLV21
ŏ7KHRSHUDWLRQVSHHGRIWKHDLOHURQHOHYDWRUDQG
ÁDSVHUYRVFDQEHDGMXVWHGIRUHDFKVQDSUROO
GLUHFWLRQ,QVLGHRXWVLGH
(Example) Setting example for F3A
ŏ0RGH>0DVWHU@
ŏ6DIHW\6:>6:*@6DIHW\PHDVXUH
ŏ0DVWHU6:>6:+@0DLQVZLWFKIRU
H[HFXWLQJVQDSUROO
ŏ'LUHFWLRQVZLWFKHV
*The snap roll up side left and right and down side left and
right direction switches are selected here.
5LJKW8S>6:'@2))2))21
5LJKW'RZQ>6:'@212))2))
/HIW8S>6:$@2))2))21
/HIW'RZQ>6:$@212))2))
ŏ6SHHGDGMXVWPHQW
The operation speed of each control
VXUIDFHZKHQWKHVQDSVZLWFKLV21FDQ
be changed and snap roll executed by
VWLFNZKLOHWKHUHLVVZLWFKRSHUDWLRQFDQEH
performed.
ŏ6HOHFW>6QDSUROO@DWWKHPRGHOPHQX
and call the setup screen shown
below.
Tonextpage
MasterorSingleis
chosen
Snaproll
directions
TheON/OFFswitch
ofsnaprollischosen.
Thesafetyswitchis
chosen.
Mastermode:Direction
switches
Singlemode:Snaproll
switches
Conditiongroup/
singlemode
selection(Gr./Sngl)
Aileron,elevatorand
Rudderrateadjustment
Inspeed
Outspeed
(First)0〜27(Slowly)
ŏ5HWXUQWR0RGHOPHQX