FUTABA T16SZ

152
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
ELEVATOR
(RUDDER2)
RUDDER
(ELEVATOR2)
V-Tail
>&RUUHVSRQGLQJPRGHOW\SH@$LUSODQHJOLGHU7DLOW\SH9WDLO
This function lets you adjust for left and right rudder
angle changes at elevator and rudder operation of a
9WDLODLUSODQH
9WDLOLVZKHQVHUYRVDUHXVHGWRJHWKHUWRFRQWURO
rudder movement as elevators. In addition to each
rudder side moving up and down together, each side
moves in opposite directions when moving as elevators.
2QD9WDLOWKLVLVDOVRNQRZQDVDUXGGHUYDWRUDVWKH\
can serve the same purpose.
(Rudderfunction)
Leftandrighttraveladjustmentat
CH1andCH2rudderoperation
(Elevatorfunction)
Upanddowntraveladjustmentat
CH1andCH2elevatoroperation
ŏ6HOHFW>97DLO@DWWKHPRGHOPHQXDQGFDOO
the setup screen shown below.
ŏ7UDYHODGMXVWPHQW
Tap to the item you want to adjust.
 $GMXVWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
SRODULW\RU
,IDODUJHYDOXHRIWUDYHOLVVSHFL¿HGZKHQWKHVWLFNVDUH
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
Conditiongroup/
singlemode
selection(Gr./Sngl)
ŏ5HWXUQWR0RGHOPHQX