FUTABA T16SZ

33
＜ BeforeUse ＞
ŵŚœœśŶť ŦūŃŰƒƇƈ
7KH56%UHFHLYHULVDYHU\YHUVDWLOH
XQLW,WKDV3:0RXWSXWV6%86DQG6%86
outputs. Additionally the PWM outputs can be
FKDQJHGIURPFKDQQHOVWRFKDQQHOV,I
you only desire to use it as an 8 channel receiver
ZLWKRXW6%86LWFDQEHXVHGZLWKRXWDQ\
setting changes.
7KH76=KDVWKHDELOLW\WROLQNWRWZR
56%UHFHLYHUV2QHRIWKHPRXWSXWWLQJ
channels 1-8 and the other outputting channels
JLYHV\RX3:0FKDQQHOV,QVWUXFWLRQV
for this configuration and S.BUS operation
IROORZ
>+RZWRFKDQJHWKH56%&KDQQHOPRGH@
1. Press and hold down the Link/Mode button
RQWKH56%UHFHLYHU
2. Turn the receiver on while holding down
the Link/Mode button. When the LED
begins to blink green/red the button may
be released.
3. The LED should now be blinking red in one
of the patterns described by the chart
below.
4. Each press of the Mode/Link button
advances the receiver to the next mode.
5. When you reach the mode that you wish
to operate in, press and hold the Mode/
Link button for more than 2 seconds.
6. Once locked into the correct mode the
LED will change to a solid color.
7. Please cycle the receiver(s) power off and
back on again after changing the Channel
Mode.
Receiver
connector
Settingchannel
ModeA
1-8CH
ModeB
1-7CH
ModeC
9-16CH
ModeD
9-15CH
1 1199
2221010
3331111
4441212
5551313
6661414
7/B 7 7 15 15
8/SB 8 S.BUS 16 S.BUS
RedLEDblink 1time 2times 3times 4times
R7008SB CH MODE TABLE
DANGER
Don'ttouchwiring.
*Thereisadangerofreceivinganelectricshock.
Donotshort-circuitthebattery
terminals.
*Ashortcircuitacrossthebatteryterminalsmay
causeabnormalheating,fireandburns.
Pleasedoublecheckyourpolarity
( ＋ and − )whenhookingupyour
connectors.
*If＋and −ofwiringaremistaken,itwilldamage,
igniteandexplode.
Don'tconnecttoExtraVoltagebefore
turningonareceiverpowersupply.
Default