FUTABA T16SZ

174
＜ Data ＞
Setting by curve type
When the curve type is selected as described above, adjustment items corresponding to the curve type
appear on the screen. Adjust each curve as described below.
YHUWLFDOGLUHFWLRQ@
7DSWRWKH>2IIVHW@VHWWLQJLWHP
0RYHWKHFXUYHLQWKHYHUWLFDOGLUHFWLRQ
XVLQJWKHʈʈʈʆʆʆEXWWRQV
 ,QLWLDOYDOXH
(When the value is tapped, the rate is reset to the initial
value.)
EXP1/EXP2 curve adjustment
(;3FXUYH
Using the EXP1 curve is effective in
smoothing starting of the ailerons, elevator,
rudder, etc.
(;3FXUYH
Using the EXP2 curve is effective in engine
rise and other engine control.
The curve left and right rates ([Rate A], [Rate
B]) and EXP curve rate ([EXP A], [EXP B]) can
be adjusted individually. ([EXP] for EXP2)
The curve can also be offset horizontally
([Offset]) in the vertical direction.
[Rate setting]
7DSWRWKH>5DWH$@>5DWH%@>(;3$@RU>(;3
%@VHWWLQJLWHP
6HWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
EXWWRQV
 ,QLWLDOYDOXHUDWH(;3UDWH
*Initial value differs depending on function.
 $GMXVWPHQWUDQJHaUDWH
a(;3UDWH
(When the value is tapped, the rate is reset to the initial
value.)
>2IIVHWWLQJWKHFXUYHKRUL]RQWDOO\LQWKH
*>6HSDU@PRGH Normal setting
*>&RPE@PRGH&UHDWHVDOHIWDQGULJKW
V\PPHWULFDOFXUYH