FUTABA T16SZ

136
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Ailerons,flaps
andelevatorsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Activatethefunctionby
tappingthe[INH].
Cambermixing
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function adjusts the rate of camber
operation which operates the wing camber
(ailerons, camber flaps, brake flaps) in the
negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently by curve, and attitude changes
caused by camber operation can be corrected.
*Initial setting assigns camber operation to side lever LS.
ŏ7KHXSGRZQVLGHUDWHVRIWKHDLOHURQÁDSDQG
HOHYDWRUVHUYRVFDQEHDGMXVWHGE\FXUYH:KHQ
WKHPL[LQJGLUHFWLRQLVUHYHUVHGE\WKHOLQNDJH
adjustments can be made by changing the
PL[LQJUDWHSRODULW\RU
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
VHWWLQJDVZLWFK$OZD\V21DW>@VHWWLQJ
ŏ$GHOD\FDQEHVHWIRUHDFKFRQGLWLRQ$FXW
VZLWFKZKLFKFDQWXUQ2))WKHGHOD\IXQFWLRQFDQ
be set.
ŏ7KHVSHHGRIWKHDLOHURQÁDSDQGHOHYDWRUVHUYRV
FDQEHVHW,QVLGH2XWVLGH
Servospeedsetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
ŏ6HOHFW>&DPEHUPL[LQJ@DWWKHPRGHO
menu and call the setup screen
shown below.
Conditiondelaycut
switch
Conditiondelaysetting
ŏ5HWXUQWR0RGHOPHQX