FUTABA T16SZ

144
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Trimmix1/2
[Corresponding model type]: Glider, general
These functions call the ailerons, elevators, and
ÀDSVFDPEHUÀDSVEUDNHÀDSVWULPRIIVHWUDWHV
SUHVHWDFFRUGLQJWRWKHÀLJKWVWDWH
The amount of ailerons, elevator, and flaps
FDPEHUÀDSEUDNHÀDSWULPRIIVHWFDQEHVHWWR
a switch.
As an example Trim mix 1 can be set up for
ODXQFKLQJZLWKVSHHGÀDSVDQGDLOHURQVGURSSHG
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
DLOHURQVDQGVSHHGÀDSVUHÀH[HGVOLJKWO\DQGDELW
of down elevator.
The trim functions can be activated during
ÀLJKWE\VHWWLQJDVZLWFK7RSUHYHQWVXGGHQWULP
FKDQJHVZKHQVZLWFKLQJÀLJKWFRQGLWLRQVDGHOD\
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
Theoffsetrateofailerons,flapsandelevatorscanbeadjusted.
Taptothecorrespondingsettingitem.Adjusttherate.
Example
0RYHWRWKH>,1+@LWHP
.
Set the trim mix function to
>21@
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
6HOHFWWKH212))VZLWFK
3. Select the [Manual] or [Auto] mode.
 ,QWKH>$XWR@PRGHDOVRVHOHFWDQDXWR6:7KLV
VZLWFKFDQEHOLQNHGWRDVWLFNHWF
<Speed>
 ,Q7KHRSHUDWLRQVSHHGDWVZLWFK21FDQEHVHW
 2XW7KHUHWXUQVSHHGDWVZLWFK2))FDQEHVHW
)LQH7XQLQJ!
 7KHRIIVHWUDWHFDQEHYDULHGLQWKH)LQH7XQLQJ
QXPHULFUDQJHVHWDWVFUHHQE\95HWFVHOHFWLRQ
<Condition Delay>
 :KHQÁLJKWFRQGLWLRQVDUHVHWWKHRSHUDWLRQVSHHG
can be set for each condition. Condition delay
operation can be interrupted and each rudder
TXLFNO\UHWXUQHGWRLWVRULJLQDOSRVLWLRQE\VHOHFWLQJD
cut switch.
ŏ6HOHFW>7ULPPL[RU@DWWKHPRGHO
menu and call the setup screen
shown below.
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
TheON/OFFswitchof
mixingischosen.
Manual/Automode
selection
Manual:Switchesthe
functionON/OFFby
switch
Auto:Trimmixfunction
callcanbelinkedtoa
stick,etc.Astickswitch,
etc.separatefromthe
functionON/OFFswitch
isset.
Conditiondelaysetting
Conditiondelaycut
switch
Inspeed
Outspeed
（First）0〜27（Slowly）
*Thedisplayscreenisanexample.Theactual
screendependsontheModelType.
WhenafinetuningVR
isset,thetrimrates
ofailerons,flapsand
elevatorscanbeadjusted.
Tonextpage
ŏ5HWXUQWR0RGHOPHQX
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.