FUTABA T16SZ - Display Mode Selection; Fine Tuning VR Settings

169
＜ ModelMenu(HelicopterFunctions) ＞
ƔDiplay mode selection
*When [rpm] mode is selected above setting, the display
mode can be selected.
* There is no change in the transmitter output even when the
"Mode" is changed. Calibration should be performed via the
governor.
* In order to use the Governor function of the T16SZ, it is
necessary to change the settings on the governor for the low
side 700 rpm mode.
:KHQWKH0RGHRIWKH*RYHUQRUVFUHHQV
PRGHOPHQXLVFKDQJHGWKHFKDQJHLVDOVR
LQGLFDWHGRQVFUHHQ
Thechartbelowindicatesthe
modepercentageandthe
correspondingRPM.
mainrotorR.P.M.
3900rpm
2700rpm
2100rpm
0% 100% 110%
mainrotorR.P.M.settingchanneltravel
50%:neutral
2500rpm
2000rpm
1500rpm
1000rpm
700rpm
3500rpm
ƔFine tuning VR settings
 7DSWRWKH>@LWHPDQGWDSWKHVFUHHQWR
DFFHVVWKHVHOHFWLRQVFUHHQ6HOHFWWKH
FRQWURO
*For a description of the switch selection method, see the
description at the back of this manual.
 7DSWRWKHUDWHLWHP
 $GMXVWWKHWULPUDWHXVLQJWKHʈʈʈʆ
ʆʆEXWWRQV
 ,QLWLDOYDOXHUSP
 $GMXVWPHQWUDQJHa
*When the screen is tapped for one second, the sensitivity is
reset to the initial value.
 7DSWKHVFUHHQWRUHWXUQWRWKHFXUVRUPRGH