FUTABA T16SZ

61
＜ Systemmenu ＞
6%866%86
6HUYR
ZD\KXERU
<KDUQHVVHV
5HFHLYHU
EDWWHU\
Procedure for changing S.BUS servo setting
6HOHFW>6%XVVHUYR@RIWKH6\VWHPPHQX
:LUHWKHVHUYRDVVKRZQLQWKHÀJXUHDERYH
3UHVV>5HDG@7KH,'DQGFXUUHQWVHWWLQJRI
WKDWVHUYRDUHGLVSOD\HG
S.Busservo
6%86VHUYRVHWWLQJ
ŏ&DOOWKHIROORZLQJVHWWLQJVFUHHQE\SUHVVLQJWKH
>6%866HUYR@EXWWRQLQWKH6\VWHPPHQX
ƔServo ID number
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
WKDWVSHFL¿FVHUYR
An S.BUS(2) servo can memorize the channel
and various settings you input. Servo setting can
be performed on the T16SZ screen by wiring the
VHUYRDVVKRZQLQWKH¿JXUH
* With some S.BUS(2) servos, there are some functions which
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
* After reading completion, with connection of the above
¿JXUHLIDVWLFNLVPRYHGVHUYRRSHUDWLRQFDQEHWHVWHG
76=
SERVO SERVO
3-way hub
or Y-harnesses
SERVO SERVO SERVO
:KHQPXOWLSOHVHUYRVDUHFRQQHFWHGFKDQJH
>,1+@DWWKHULJKWVLGHRIWKH,'QXPEHURQWKH
VFUHHQWR>$&7@DQGHQWHUWKH,'RIWKHVHUYR
\RXZDQWWRVHW
6HWHDFKLWHP3OHDVHVHHWKHQH[WSDJH
3UHVV>:ULWH@7KHVHWWLQJVDUHFKDQJHG
ŏ5HWXUQWR6\VWHPPHQX