FUTABA T16SZ

141
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Setting method
ŏ7DS>,1+@
 21LVGLVSOD\HG
ŏ:KHQVHWWLQJDVZLWFKWDSWRWKH>@LWHP
of the switch and tap the screen to call the
selection screen. Then, select the switch and
VHWLWV21GLUHFWLRQ$OZD\V21DWVHWWLQJ
 )RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJ
LWHPDQGWDSWKHVFUHHQWRFDOOWKH
VHOHFWLRQVFUHHQDQGWKHQVHOHFWWKH957KH
adjustment rate can be set.
7KH95RSHUDWLRQPRGHFDQDOVREHVHW
 )RUDGHVFULSWLRQRIWKHÀQHWXQLQJ95VHWWLQJ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ$PL[LQJFXUYHFDQEHVHW
 )RUDGHVFULSWLRQRIWKHFXUYHVHWWLQJ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ:KHQOLQNLQJWDSWKH>/LQN@LWHP21LV
GLVSOD\HG
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Up/Downoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
Tosetlinking,tapto
the[OFF]item
Rudder → Elevator
[Corresponding model type]: Airplane, general
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder
is applied in roll maneuvers, knife edge, etc. of
acrobatic planes.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
VHWWLQJDVZLWFK$OZD\V21DW>@VHWWLQJ
ŏ/LQNFDQEHVHW/LQNVWKLVPL[LQJWRRWKHUPL[LQJV
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
)LQHWXQLQJ
ŏ6HOHFW>5XGGHUń(OHYDWRU@DWWKH
model menu and call the setup
screen shown below.
ŏ5HWXUQWR0RGHOPHQX