FUTABA T16SZ

135
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Elevator
→
Camber
Elevator
→
Camber
Elevator
→
Camber
Elevator → Camber
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function is used when you want to mix the
FDPEHUÀDSVZLWKHOHYDWRURSHUDWLRQ:KHQXVHG
WKHÀDSVDUHORZHUHGE\XSHOHYDWRUDQGOLIWFDQ
be increased.
Note: Tailless wing elevator can be operated
when this mix is activated.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
VHWWLQJDVZLWFK$OZD\V21DW>@VHWWLQJ
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
Setting method
ŏ7DS>,1+@
 21LVGLVSOD\HG
ŏ:KHQVHWWLQJDVZLWFKWDSWKH>@LWHPRI
the switch and tap the screen to call the
selection screen, and then select the switch
DQGVHWLWV21GLUHFWLRQ$OZD\V21DW
VHWWLQJ
 )RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJ
LWHPDQGWDSWKHVFUHHQWRFDOOWKH
VHOHFWLRQVFUHHQDQGWKHQVHOHFWWKH957KH
adjustment rate can be set.
 7KH95RSHUDWLRQPRGHFDQDOVREH
selected.
ŏ$PL[LQJFXUYHFDQDOVREHVHW
 )RUDGHVFULSWLRQRIWKHFXUYHVHWWLQJ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ6HOHFW>(OHYDWRUń&DPEHU@DWWKHPRGHO
menu and call the setup screen shown
below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Aileronsandflapsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
FinetuningVRsetting
Operationmode
Adjustmentrate
Activatethefunctionby
tappingthe[INH].
ŏ5HWXUQWR0RGHOPHQX
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.