FUTABA T16SZ

150
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
[Corresponding model type]: Glider, general
Acceleration
Setting method
ŏ$FFHOHUDWLRQUDWHVHWWLQJ5DWH
ŏ7KHUHWXUQWLPHDIWHURSHUDWLRQ'DPSLQJ
can be set.
ŏ7KHRSHUDWLRQSRLQWDWDFFHOHUDWLRQ
DQGGHFHOHUDWLRQFDQEHVHW:KHQDQ
operation point is exceeded, acceleration is
performed.
ŏ6HOHFW>$FFHOHUDWLRQ@DWWKHPRGHO
menu and call the setup screen shown
below.
Acceleration setting can be performed at Elevator,
(OHYDWRUĺ&DPEHUDQG$LOHURQĺ5XGGHU*OLGHU
only)
ŏ7KLVVHWWLQJLVGLYLGHGLQWRHOHYDWRUVHWWLQJDQGFDPEHU
setting. The setting method is the same.
ŏ&DPEHUVHWWLQJVHWVWKHDFFHOHUDWLRQIXQFWLRQIRU(OH
WRFDPEHUPL[LQJ6HWWLQJLVQRWSHUIRUPHGZKHQ(OHWR
FDPEHUPL[LQJLV,1+
ŏ7KHDFFHOHUDWLRQIXQFWLRQFDQEHVHWIRUERWKWKHXS
side and down side.
ŏ)XQFWLRQ212))VZLWFKVHWWLQJLVSHUIRUPHGIRU
$LOHURQń5XGGHUVHWWLQJRQO\
ŏ$LOHURQń5XGGHUVHWWLQJLVDFFHOHUDWLRQ
IXQFWLRQVHWWLQJIRU$LOHURQń5XGGHUPL[LQJ,WLVQRW
SHUIRUPHGZKHQ$LOHURQń5XGGHUPL[LQJLV,1+
1RWH:KHQXVLQJWKHDFFHOHUDWLRQIXQFWLRQ
VLQFHWKHVHUYRVWURNHLVODUJHPDNH\RXU
VHWWLQJVVRWKHUHLVQRELQGLQJRI\RXUOLQNDJH
Operationuptothis
rangewillinitiate
acceleration.
Actposition
Theratetheangle
increases.
Tonextpage
2/3:Elevator → Camber
3/3:Aileron → Rudder
Thereturntimeafteroperation(Damping)
canbeset.
（Firstreturn）1 〜 100（Slowreturn）
（Accelerationdoesn'tfunctionas0.）
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
Conditiongroup/
singlemodeselection
(Gr./Sngl)
Currentposition
ŏ5HWXUQWR0RGHOPHQX