FUTABA T16SZ - Setting Three Axis Using a G A44 and G A441 (2)

148
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
(Example) Setting three axis using a G<A44 and G<A441 (2)
ŏ:LQJW\SH$LOHURQVHUYRVPRXQWHGIXVHODJHVHOHFWHG
ŏ6HW
5CH → Gyro
*<$$,/
7CH → Gyro2
*<$(/(
8CH → Gyro3
*<$58'
ControlandTrim → "--"
: at
WKH)XQFWLRQPHQXRIWKH/LQNDJHPHQX
ŏ*\URVHWWLQJRIWKH0RGHOPHQX
*Set so that Rate 1 is turned on at the back position of switch E
and Rate 3 is turned ON at the front position. Since switch E is
turned OFF at the center, Rate 2 remains [INH].
Rudderservo
Elevatorservo
GYA440
GYA441
GYA441
Aileronservo
S.BUS2port
R7008SB
GAIN0％
AVCS
NORMAL
WhenAVCSisusedwe
recommendthatthe
sensitivityCHbesetto
the3-position.
Rate ACT Type Switch Gyro Gyro ２ Gyro ３
1 OFF/ON GY SE AVCS:60% AVCS:60% AVCS:60%
2INH
3 ON/OFF GY SE Normal:60% Normal:60% Normal:60%