138
< Modelmenu(Airplane/Glider/MulticopterFunctions) >
ELEVATOR
ELEVATOR2
AILVATOR
AIRBRAKE
V-TAIL
ELEVATOR ELEVATOR2
Airbrake →ELE
[Corresponding model type]:
Airplane/glider, general
This mix is used when you want to mix the
elevators with airbrake (spoiler) operation. It
raises the elevators to correct for dropping of the
nose during airbrake operation.
*This function does not operate when airbrake is not assigned
at the Function menu in the Linkage menu.
ŏ7KH5DWHVLGH5DWHVLGHPL[LQJUDWHZLWKWKH
elevator servos can be adjusted.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
VHWWLQJDVZLWFK$OZD\V21DW>@VHWWLQJ
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŏ6HOHFW>$LUEUDNHń(/(@DWWKHPRGHO
menu and call the setup screen shown
below.
*The display screen is an example. The actual
screen depends on the model type.
Adjustmentof
elevatorservo
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Up/Downoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
Setting method
ŏ7DS>,1+@
21LVGLVSOD\HG
ŏ:KHQVHWWLQJDVZLWFKWDSWKH>@LWHPRI
the switch and tap the screen to call the
selection screen, and then select the switch
DQGVHWLWV21GLUHFWLRQ$OZD\V21DW
VHWWLQJ
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
this manual.
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJ
LWHPDQGWDSWKHVFUHHQWRFDOOWKH
VHOHFWLRQVFUHHQDQGWKHQVHOHFWWKH957KH
DGMXVWPHQWUDWHFDQEHVHW7KH95RSHUDWLRQ
mode can also be set.
)RUDGHVFULSWLRQRIWKHÀQHWXQLQJ95VHWWLQJ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ$PL[LQJFXUYHFDQEHVHW
)RUDGHVFULSWLRQRIWKHFXUYHVHWWLQJ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
ŏ5HWXUQWR0RGHOPHQX