FUTABA T16SZ

131
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
FLP2
(CamberFlap)
FLP1
(CamberFlap)
FLP3
(BrakeFlap)
FLP4
(BrakeFlap)
Flapsetting
[Corresponding model type]: Airplane/
JOLGHUÁDSVRUPRUH@
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
ŏ7KHRSHUDWLRQUHIHUHQFHSRLQWRIHDFKÁDSFDQEH
offset
7KHFDPEHUÀDSVRIDÀDSPRGHOFDQEHPL[HG
ZLWKWKHEUDNHÀDSV%UDNH)/3WRFDPEHU)/3
ŏ$Q212))VZLWFKFDQEHVHW
Setting method
ŏ7DSÁDS)/3aXSRUGRZQDFFRUGLQJWR
the wing type.
Adjust the travel independently.
ŏ7RRIIVHWWKHRSHUDWLRQUHIHUHQFHSRLQWRI
HDFKÁDSWDSWKHFRUUHVSRQGLQJRIIVHWLWHP
8VHWKHʈʈʈʆʆʆEXWWRQWRRIIVHW
the reference point.
ŏ:KHQXVLQJEUDNH)/3WRFDPEHU)/3PL[LQJ
WDSWKH>,1+@LWHPDQGWDSWKHVFUHHQ21LV
GLVSOD\HG
 :KHQVHWWLQJDVZLWFKWDSWKH>@LWHPRI
the switch and tap the screen to call the
selection screen. Then, select the switch and
VHWLWV21GLUHFWLRQ$OZD\V21DWVHWWLQJ
 )RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQ
PHWKRGVHHWKHGHVFULSWLRQDWWKHEDFNRI
WKLVPDQXDO
Camberflapsetting Brakeflapsetting
ŏ6HOHFW>)ODSVHWWLQJ@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
*Thedisplayscreenisan
example.Theactualscreen
dependsontheModel
Type.
Conditiongroup/single
modeselection(Gr./Sngl)
(Formoreinformation,see
thedescriptionattheback
ofthismanual.)
Currentlyselectedconditionname
BrakeflaptoCamberflapsetting
Operationreference
pointoffset
Operationreference
pointoffset
Upside/Downside
adjustment
Upside/Downside
adjustment
TheON/OFFswitchof
mixingischosen.
Mixing
INH ⇔ ON
Operationisperformedviathevolume
switches,etc.,setforeachflapcontrolofthe
function.
Theoperationalvolume
switchissetupby"Function"
ŏ5HWXUQWR0RGHOPHQX