Futurecom VR - Page 113

8G093X01 R5
VR Programming Guide
August 2022 Page 113 of 144
Field Name
Range
Description
Notes
PSU Initiated VR Mode Change
Classic Operation
Check box
(checked)
When enabled (checked), on receiving a
call alert (Page) from Local PSU the VR
can steer MSU channel and change VR
mode from OFF / LOCAL to SYSTEM
mode.
- VR Mode
changes to
SYSTEM
regardless of
programmed
Repeater
Channel
Setup→VR
Mode or Mobile
Radio Channel
Setup→TG
Mode for the
channel.
- Refer to Table 8
- Mode Change
Handling for all
scenarios
including
exception where
SYSTEM mode
is not allowed.
- Classic
Operation is
recommended
for vehicular
deployment
Flexible Operation
Check box
(unchecked)
Selectable Modes:
SYSTEM, LOCAL,
OFF all checked
by default
If enabled, on receiving a call alert
(Page) from Local PSU the VR can steer
MSU channel and change VR mode to
that programmed for the MSU channel or
cycle through VR modes (SYSTEM,
LOCAL & OFF) based on checkboxes
selected
- Selecting only
OFF checkbox
is not allowed in
Flexible
operation.
- Upon MSU
Channel
Steering, the
Mobile Radio
Channel
Setup→TG
mode assigned
to the channel
takes priority.
- Flexible
Operation is
more suitable
for Fixed
Location
deployment
*Note for operation on Authentication capable systems:
• On Simplex VR channel, when Talkaround (TA) upon no DVRS communication is enabled
in the PSU programming, consider disabling Duplicate ID detection from Generic PSU voice
call on VR by setting Declare Duplicate ID condition after N Generic PSU calls to Disable.
• It is recommended to disable BL; since due to the System Authentication timing, the VR may
process messages/emergency alerts from a non-authenticated duplicate ID LPSU.