Futurecom VR - Page 132

8G093X01 R5
VR Programming Guide
August 2022 Page 132 of 144
Control Head Display
Description / Action
Affichage de la tête de
commande
RC ERREUR 4000
Configurator to upgrade the EEPROM map as described in the
Firmware upgrade instructions provided by Futurecom.
RF ERROR 1000
Transceiver DSP alarm (invalid checksum). Try re-flashing the
firmware and if error still present, contact Futurecom to obtain an
RMA and shipping instructions.
RF ERREUR 1000
RF ERROR 2000
Baseband DSP alarm (invalid checksum). Try re-flashing the
firmware and if error still present, contact Futurecom to obtain an
RMA and shipping instructions.
RF ERREUR 2000
RF ERROR 400
Tx synthesizer lock alarm. Use another Tx frequency, if possible. If
not, contact Futurecom to obtain an RMA and shipping instructions.
RF ERREUR 400
RF ERROR 4000
Transceiver DSP alarm (failed to load / start). Try re-flashing the
firmware and if error still present, contact Futurecom to obtain an
RMA and shipping instructions.
RF ERREUR 4000
RF ERROR 800
Rx synthesizer lock alarm. Use another Rx frequency, if possible. If
not, contact Futurecom to obtain an RMA and shipping instructions.
RF ERREUR 800
RF ERROR 8000
Baseband DSP alarm (failed to load / start). Try re-flashing the
firmware and if error still present, contact Futurecom to obtain an
RMA and shipping instructions.
RF ERREUR 8000
SCN LIST ERR
Displayed temporarily when Scan and VR are turned ON while band
locking is enabled in the VR and the MSU scan list contains
members using the same frequency band as the VR.
SYNC ERROR
WARNING 8000 / 9000
Indicates the MSU programming has been changed but the VR
template has not been updated. Requires export and import of the
new MSU .XML file in the VR. When using the DVRS File, the hash
in the template must match the hash in the DVRS File (FRC MSU
Data → Unit Field Hash). If not, VR will report hash mismatch as
"SYNC ERROR".
SYNC ERREUR
ATTENTION 8000 /
9000
TRANSL TG WRN
This warning is displayed when a talkgroup in the talkgroup
translation table is active on the Trunking system. The VR (and
respectively PSU) programming must be changed so that valid
system TG IDs are not used for Translation.
TRANSL TG ATT
VR ERROR and RC ERROR
XXXX or RF ERROR XXXX
(Alternating)
Turn the VR off and then back on. If it does not correct the condition,
note the exact error code and contact Futurecom to obtain an RMA
and shipping instructions.
RV ERREUR
VR PROGRAMMING
Indicates the VR is being programmed and the MSU is on standby.
RV PROGRAMME
WARNING 0400 / 0800
Displayed upon power up only indicates that the Main / Backup
EEPROM map of the VR contains corrupted data. The VR will still
operate properly from the alternate EEPROM map. To fix the
corrupted map, please use the latest Futurecom Repeater
Configurator to read the VR. This will restore the Main / Backup
EEPROM Map.
ATTENTION 0400 /
0800
WARNING 20000 DVRS
DISABLE
Set the channel type to Analog or contact Futurecom to purchase a
license upgrade if a different channel type is required.
ATTENTION 20000